Page 1 of 1

APCD question

PostPosted: Thu Dec 18, 2014 12:52 pm
by GoesForIt
I've attached a screen shot.

I'm just getting started with APCD. I've listened to the first 16 YouTube videos on the subject.

I've tried to create a one hole test course. It seeems like I've done everything in the videos, but when I do the "Checklist" it continually says I need to "Insert Shapes Into Terrain"... which I feel I've done... at least according to the YouTube videos.

Anyone got any ideas?

GoesForIt

Re: APCD question

PostPosted: Thu Dec 18, 2014 1:52 pm
by gd5150
You should check out the forum at Links Corner, there's a whole section on APCD with a ton of info.

Re: APCD question

PostPosted: Thu Dec 18, 2014 2:17 pm
by Steve Sullivan
Have you planted a tee and a pin? APCD expects that to make a hole playable in Links.

I have never inserted shapes. I always click on Advanced Settings when defining my hole paths

APCD-1.jpg
APCD-1.jpg (75.27 KB) Viewed 5668 times


Then select the bottom option once there

APCD-2.jpg
APCD-2.jpg (162.9 KB) Viewed 5731 times

Re: APCD question

PostPosted: Thu Dec 18, 2014 4:44 pm
by GoesForIt
I now remember Lez saying to click...

Create Hole Boundary Shape...

and when I did this one hold test course I forgot.

THANKS! BUNCHES

Re: APCD question

PostPosted: Thu Dec 18, 2014 6:13 pm
by GoesForIt
THANKS AGAIN. I got my single hole test to work and can now set about all remaining YouTube Videos and at least laying out the holes for my course.

Oh! And I got a birdie on my first hole... as the green was pan flat.